Installation - S&P EDM-200 Manual

ENGLISH
The EDM-200 range extractors have been manufactured to the rigorous stan-
dards of production and quality as laid down by the international Quality Stan-
dards ISO 9001. All the components have been checked and all the final products
have been tested at the end of the manufacturing process.
We recommend you to check the following when receiving this product:
1. That it is the correct size.
2. That it is the correct model.
3. That the details on the rating label are those you require: voltage, frequency...
The installation must be in accordance with the electrical standards in force in
your country.

INSTALLATION

IMPORTANT: Before installing and wiring the EDM, ensure that the main supply
is disconnected.
Fig.1:
1. Protection grille
2. Cable entry
3. Flange
4. Fixing screw
The EDM can be installed on wall or ceiling, and the discharge can be made
direct to the outside or to a ducting (individual or shunt, fig. 2).
The hole to be made on the wall or the ceiling must have the following diameter:
125 mm.
Loosen the screw (4) fixing the grille (1). Bind the adhesive tape supplied around
the outlet (6).
If the installation is made to an individual ducting, use standard ducting: 120 or
125 mm.
Ensure that there are no obstructions to the airflow and that the impeller turns
freely.
Fix the extractor to the wall with the 4 plugs and screws supplied in the packa-
ging. The unit must be fixed in such a way that it is not stressed, to avoid noise
generation or problems in the rotation of the impeller. Connect the electrical
wiring as explained hereafter and then mount the protection grille and fixed it by
tightening the screw (4).
5. Connection terminals
6. Outlet
7. Slot
EN
11