Advertisement
GPS Trackers for Every Scenario
Optimus 2.0 Bundle Manual
To activate your tracker,
please follow these easy steps
About your Tracker
· ON: Use the top button, press down hard for 3 seconds until the light
starts to flash, the tracker will also turn on automatically when you
connect the battery charger.
· OFF: Use the top button, press down hard for 3 seconds until you feel
the vibrator and let go. The tracker may take up to 1 munute to fully turn
off.
GPS:
Flashing : Searching for GPS signal
Solid for 5 seconds: GPS fix succesful
BATTERY:
Flashing : Battery is low, or Battery
is charging.
Solid : Charging is complete
CELLULAR:
Flash 3 times/sec. Searching for cellphone
signal
Flash 1 times/sec. Connected to cellphone
signal
Take the device outside to acquire signal
Installation videos: optimustracker.com/pages/videos
Vehicles | Assets | People
Go to our website
www.OptimusTracker.com
Click on the "Activate Tracker" link.
Fill out the form. You will need the
IMEI number.
It's the 15-digit number that is printed
on the tracker's labels.
After subscribing, wait a minute for
the activation email.
Make sure to check your spam/junk
folder too.
Activate before installing
Power Button
SOS Buttom
1
2
3
3in. x 1in. x 1.5 in.
4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Optimus 2.0
Summary of Contents for Optimus 2.0
- Page 1 GPS Trackers for Every Scenario Vehicles | Assets | People Optimus 2.0 Bundle Manual To activate your tracker, please follow these easy steps Go to our website www.OptimusTracker.com Click on the “Activate Tracker” link. Fill out the form. You will need the IMEI number.
- Page 2 A little more information · After activation, turn your tracker on and take it outside. Wait a few minutes. · Your tracker should appear on the map soon after. If your tracker does not appear on the map, please contact us. ·...
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers
Why is there a “dead zone” in the overnight hours? When pm becomes am there are no readings
A "dead zone" in readings for the Optimus 2.0 during overnight hours is caused by reduced input voltage, indicated by the display message “Waiting Sun.” During this time, the alarm contact remains in its resting position, meaning no active data or operation occurs due to lack of sunlight.
This answer is automatically generated