INSTRUCTIONS
PLL BALLAST COMPATIBLE
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
PLL-14-8XX-DIR
IMPORTANT
READ CAREFULLY BEFORE INSTALLING LAMPS. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
lamps
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaire electrical systems. If not qualified,
do not attempt installation. Contact a qualified electrician. Installation should be performed only by a qualified electrician
in accordance with the National Electrical Code and relevant local code.
•
Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown
in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the
luminaire.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTION
•
RISK OF FIRE. IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY
TURN OFF POWER, REMOVE LAMP FROM LUMINAIRE AND CONTACT THE MANUFACTURER.
•
Disconnect power at the source before installation, inspection or removal. Do not simply switch off fixture.
•
Not intended for use with emergency exit fixtures or emergency exit lights.
•
THIS LAMP ONLY OPERATES ON ELECTRONIC PROGRAMMABLE BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE
IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND CONTACT LAMP MANUFACTURER OR QUALIFIED ELECTRICIAN.
•
This lamp is not compatible with all ballasts. Before replacing existing fluorescent lamps, check compatibility of LED lamps
and luminaire ballast.
•
Do not use if product is damaged.
•
This lamp might not be compatible with all dimmers. Please visit rablighting.com for compatability information.
•
Risk of fire or electric shock. Do not open or modify. No user serviceable parts inside.
•
SUITABLE FOR DAMP LOCATIONS. Suitable for use in wet locations when used in an outdoor-rated fixture. Not for use where
directly exposed to the weather or water.
•
Complies with Part 15 of FCC. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received including
interference that may cause undesired operation.
•
No external weight or mechanical force should be applied to lamp or components.
•
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
•
THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABLILITY OF THE COMBINATION
SHALL BE DETEERMINED BY AUTHORITIES HAVING JURISDICTION.
NOTE:
•
This retrofit kit can replace 36W CFL lamps with 2G11 bases.
• MIN. LAMP COMPARTMENT DIMENSIONS 24.2" (L) x 23.8" (W) x 4.1" (H).
• Intended for operation with the following ballasts:
Philips model #: ICN-2S54-T
GE model #: GE254MVPS-D