Epson LQ-500 User Manual page 13

Choosing a Place
If you plan to use a printer stand, make sure it meets the
Note:
following requirements:
The stand must support at least 30 lb or
l
weight of the printer).
The stand must not tilt the printer more than 15 degrees from
l
horizontal. With a cut sheet feeder, the stand must keep the
printer level.
If the paper supply is below the printer stand, make sure that
l
the paper cannot catch on the underside of the stand or on
the stand supports.
Make sure that the power cord and the interface cable do not
l
interfere with paper feeding. If possible, secure them to a
printer stand support.
WARNING:
Avoid locations that are subject to direct sunlight,
l
excessive heat, moisture, or dust.
Avoid using electrical outlets that are controlled by
l
wall switches or automatic timers. Accidental
disruption of power can wipe out information both in
your computer's memory and in your printer's
memory.
Avoid using outlets on the same circuit with large
l
motors or other appliances that might disturb the
power supply.
Keep the entire computer system away from potential
l
sources of interference such as loudspeakers or the
base units of cordless telephones.
Up
1-6
Setting
the Printer
for
the Printer
kg (twice the
14