Advertisement
Available languages
Available languages
Installation manual
EXP-IO1-ADL500
Optional expansion card
Introduction
Optional expansion card (cod. S5DL408) for ADL550 drives.
Adds 4 digital inputs (DI) and 2 relay outputs (RO) to the basic
configuration.
TB1 terminal – Digital Relays Output
Pin
Signal
Description
1
RO_6O
Output Relay 6
(N.O. contact, 250V
2
RO_6C
Common Relay 6
3
RO_5O
Output Relay 5
(N.O. contact, 250V
4
RO_5C
Common Relay 5
5
-
Not connected
TB2 terminal – Digital inputs
Pin
Signal
1
DI_4X
Digital input 4X
2
DI_3X
Digital input 3X
3
DI_2X
Digital input 2X
4
DI_1X
Digital input 1X
5
DI_CM
Digital input common reference
Command
Associated parameter
1422, Dig output 2X src
/30V
, 2a)
ac
dc
1420, Dig output 1X src
/30V
, 2a)
ac
dc
Description
WEG Automation Europe S.r.l.
Via Carducci, 24 - 21040 Gerenzano [VA] ITALY
Ph. +39 02 967601 - Fax +39 02 9682653 - info.motion@weg.net - www.weg.net
Installation
Only one option card can be installed.
Use only the screws supplied with the option card.
Caution
1.
Use a Phillips screwdriver (Ph2) to loosen the 4 M3 screws
(2) and then remove the top cover (1);
2.
Secure the optional board (3) by inserting the option board's
2
J1 female connector onto the control board's P13 male
connector;
1
3.
Tighten down the 2 M3 screws (4) supplied with the option
board (3);
4.
Replace the upper cover (1) and tighten down the 4 M3
screws (2).
1S5DL408, EXP-IO1-ADL500 -EN
Manual (rev 0.2 - 6-02-2023)
2
4
3
1
Advertisement
