INSTALLATION INSTRUCTIONS
• The installation for electrical and plumbing work must be carried out by
qualified personnel, according to the installation instructions and in
compliance to the local authority regulations.
• Unit has to be installed as near as possible to the service points, in order to
reduce the heat loss along the pipes. To facilitate maintenance, allow a
distance of 50 cm for easy access to the electrical parts.
• This electrical water heater should be mounted on a solid cement wall,
preferably where it is close to the power source's sockets and water source.
• Please use our company's fitted accessories to mount this electric water
heater.
• Before determining the bolt hole's position you should ensure that the heater
is more than 200 mm from the ground or ceiling board. This will leave space
for maintenance when necessary.
• Assembling method: After selecting the proper fixing positions, use the
inflating bolt to secure the hanging board firmly, then hook the electric water
heater.
Firm cement wall
EN
29
Inflation bolt