Electrical Connection - FF Europe ELKESS-S-30L Original Instruction Manual

All maintenance operations must be carried out by qualified personnel.
● Before contacting the customer service, make sure the suspected failure is not caused
by a temporary lack of water.
● To discharge the water completely from the tank, remove the safety valve from the
water heater. Before removing the valve, the power of the heater needs to be switched
off for the tank to cool down (outlet connection must also be disconnected).
The electrical connection must be done by a qualified electrician.
• The electrical supply is connected directly to the connector provided with the
earth connection. The ground wire must be green/yellow in colour and
attached to the terminal marked by the symbol (see the symbol in manuals).
• The heater must be connected to the electricity supply that is out of reach
from the person using the shower.
• All wiring must conform to local requirements. If in doubt, please consult a
qualified electrician.
Note: The installation should be completed by a suitably qualified person.
The installation should be conducted by a suitably qualified person. All plumbing
connections must be completed before making the electrical connections. Fill the
tank with water and turn on the tap to let the water flow out from the tank until
all the air has been expelled out. Switch the electricity on after the water tank is
full of water.
• This appliance is not intended for use by persons with reduced physical, sensory,
or mental capabilities, or lack of experience and knowledge, unless they are
under the supervision of a responsible person or have been given proper
instruction for using the appliance. Children aged 8 and older are allowed to use
the appliance independently if given adequate instructions concerning safe use
and potential hazards. Children shall not play with the appliance. Cleaning and
maintenance shall not be performed by children.
EN
MAINTENANCE

ELECTRICAL CONNECTION

24