blukii Smart Beacon Go Mini Manual

Manual Smart Beacon Go Mini

Features

Smallest beacon in the blukii portfolio
•
• Can be combined with a variety of accessories such as blukii Key-Fob,
blukii Clip or blukii Drop
• Bluetooth Low Energy® 4.2
Eddystone & iBeacon compatible
•
• Management and setting of all parameters via blukii Manager and blukii
Configurator App
• Individual pre-configuration possible (MOQ: 20 pieces)

Intended Use

Smart Beacons are Bluetooth transmitters that send a unique ID to surrounding devices at certain intervals. They are used to
identify places and objects.
• This document is part of the product. It contains important information for installation and operation. Store it carefully.
Any other use than described in these instructions is not permitted. The manufacturer assumes no liability for personal
•
injury or damage resulting from improper use.
The product must not be modified
•
• If the product is damaged, it may no longer be used.
Only operate the device within the technical specifications.
•
• The product should be operated in dry and dust-free locations.
The product must not be exposed to strong mechanical loads.
•
• The beacon must be protected from strong heat.
• Do not operate the device near flammable gases and vapours.
Do not remove any stickers or labels from the product. These contain important product and safety information.
•

Assembly of Go Mini accessories

The Smart Beacon Go Mini can be used alone or in combination with numerous accessories. To install the optional accessories,
proceed as follows:
Key Fob Go Mini: Peel off the protective strip from the double-sided adhesive tape. Insert the Smart Beacon with the label
•
facing up into the Key Fob Go Mini.
• Clip Go Mini: Peel off the protective strip from the double-sided adhesive tape. Insert the Smart Beacon with the label
facing upwards into the Clip Go Mini.
Drop Go Mini: Place the Smart Beacon Go Mini in the ground. Put the top on slightly twisted and then turn it to the
•
position that the outer contour of the top and bottom part are flush.

Add Smart Beacons in the blukii manager

To be able to configure and manage your Smart Beacons in the blukii Manager, you have to add them to your blukii Manager
account. Proceed as follows:
1. Log in to https://manager.blukii.com/ with your blukii Manager account. If you don't have an account yet, you can create one for
free.
2. In the "My blukiis" section, you can add new Smart Beacons using the "+ ADD" button. Enter the activation code from your order
in the corresponding field. By clicking on the "ADD TO MY BLUKIIS" button, the Smart Beacons from your order will be assigned to
your account.
Manual Smart Beacon Go Mini
Made in Germany
16.01.2023