Related Manuals for West Elm morgan
Summary of Contents for West Elm morgan
- Page 1 ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. 797874—06/06 Page of 0...
- Page 2 Drawer back panel x 2 Leveler (pre-installed) X 4 Drawer left upper side panel x 1 Large wooden dowel X 28 Drawer left lower side panel x 1 Bolt with Flat & Lock washer x 12...
- Page 3 Back board screw X 21 Right side panel x 1 Aluminum file hanging rod X 8 Bottom panel x 1 mounting bracket X 4 Front rail x 1 Back rail x1 Long screw X 2...
- Page 4 . Screw cam lock bolts (E) into drawer side panels (,,4). . Insert cam locks (D) into holes in drawer back panel (). Be sure the arrow on the cam lock points toward the cam bolt as shown.
- Page 5 4. Screw cam lock bolts (E) into drawer front panels (6). . Slide drawer bottom panel () into drawer sides as shown. 6. Insert cam locks (D) into holes in drawer side panels. Be sure the arrow on the cam lock points toward the cam bolts. Insert cam lock bolts into cam locks and tighten with a phillips screwdriver.
- Page 6 7. Slide drawer bottom stiffeners (6) into drawer bottoms and fasten with drawer screws (G). Tighten screws with a phillips screw- driver. 8. Fasten drawer pulls (H) to drawer fronts as shown. Tighten screws with a phillips screwdriver.
- Page 7 0. Fasten legs to the base using bolts, lock washers, flat washers (C) and wooden dowels (B) in order as shown. Tighten bolts using the allen key (F). Be sure to orient legs in the correct position as shown.
- Page 8 . Insert dowels (B) into top edge of sides (8,9) as shown. 6. Fasten top to sides using bolts, lock washers, and flat washers (C) in order as shown. Tighten bolts using the allen key.
- Page 9 7. Insert dowels (B) into bottom edge of sides. 8. Fasten base to sides using bolts, lock washers, and flat washers (C) in order as shown. Tighten bolts using the allen key (F). 9. Fasten back panel (7) into back of cabinet using back board screws (I). Tighten screws with a phillips screwdriver.
- Page 10 0. Insert drawers into cabinet as shown. Upper Drawer Drawer Clip Lower Drawer . Adjust levelers as shown to prevent tipping. CARE INSTRUCTION Hardware may loosen over time. Periodically check that all connections are tight.
-
Page 11: Care Instructions
OVER BALANCE. To prevent injury and property damage from unexpected tipping of furniture, we highly recommend installation of the two (2) sets of overbalance protection hardware included with this product 1. Attach the two mounting brackets securely to the back edge of the furniture. Place one on each of the side panels.