Table of Contents
Advertisement
Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
User Manual
The cabinet does not cool sufficiently:
IT
• Check that the condensing unit is clean
and able to carry out its heat exchange
FR
function; clean thoroughly, if the fins are
obstructed.
EN
EN
• Check that the cabinet is loading correctly.
• Defrost the cabinet and then resume
DE
normal operation, if this operation has not
been carried out for more than three
ES
months.
• Check that the cabinet is not close to heat
PT
sources or air currents.
• Verify
the
reference values are contained in "Ambient
conditions" ("Chart III").
• Check the flatness of the cabinet using a
leveller.
• Check door is perfectly closed
If cooling failure persists, contact your nearest
authorised service centre.
The cabinet is noisy:
• Check screws and bolts are perfectly
tightened.
• Check the flatness of the cabinet using a
leveller.
If the inconvenience persists, contact your
nearest authorised service centre.
9.11
Technical assistance
Where technical assistance personnel are
required, contact immediately the supplier from
whom the cabinet was purchased.
If you need to use spare parts always refer to
the technical assistance service: ask and ensure
that original spare parts are used.
N°DOC. UM000692 REV. A - 20/03/2023
ambient
conditions;
MULTIWINE PLUS
Epta Spa - Via Mecenate, 86 - 20138 Milano (MI) ITALIA
Tel. 02/55403211 Telefax 02/55401023
9.12
Dismantling and elimination
IMPORTANT INFORMATION FOR CORRECT
DISPOSAL OF THE PRODUCT IN ACCORDANCE
WITH EC DIRECTIVE 2012/19/UE
For reasons connected with the safeguard of
the environment, and in compliance with what
Directive 2011/65/EC and the relevant local
national laws that establish, the cabinets for
refrigerated products and frozens must be
disposed of and recycled at the end of their life
cycle.
Making sure that this is achieved, the user
significantly
repercussions on the environment and on the
the
public health.
Cabinets including a refrigerating circuit and a
power plug (therefore ready to be installed) are
defined WEEE: "Waste Electrical and Electronic
Equipment".
• Deliver the cabinets to the appropriate
centres specialising in WEEE recovery and
recycling.
• Alternatively, return the cabinets to the
seller or to the manufacturer.
• At any rate, collection of WEEE to be
processed must be made following criteria
that guarantee the protection of the
cast-off appliances during transportation
and during their loading and unloading. Do
not leave the appliances unattended, not
even for a few days.
• Avoid damaging the refrigeration circuit,
as this contains fluids that may potentialy
be hazardous for the environment and are
subject to special prescriptions.
• Make sure that doors are closed and fasten
mobile parts accordingly.
• Remove the power plug from the cast-off
appliances and cut off their power cord in
order for them to become unusable.
The symbol appearing on the rating plate of the
appliance and on the documents attached
indicates that:
20/22
helps
prevent
potential
Advertisement
Chapters
Table of Contents
