Geti 0884 0195 Instructions

Remote controlled wireless sockets 5 + 1
0884 0195
Carefully read the following instructions. This will prevent misuse or damage to the product.
Prevent improper handling of this device. This product is designed for indoor use only. The
product should only be used by an adult. Never expose the product to a high humidity
environment (e.g., a bathroom), avoid contract with liquids.

Package contents:

• 1x remote control
• 5 x receiver – socket 16 A / 3680 W socket

Basic information

• Never connect several sockets together.
• The distance between two sockets in use should be greater than 50 cm.
• Designed for indoor use only at temperatures between 0°C and 40°C. Not intended
for outdoor use. IP20 protection.
• Do not connect the socket to an extension cord. Use only a fixed power socket on the
wall.
• Do not connect equipment that requires constant supervision – it could result in fire
or other damage (e.g., clothes iron and sources of heat).
• Do not open the socket. Repairs must be carried out only by a professional. Improper
use and handling may cause electrical shock or short circuit.
• The remote control has a range of max. 30 m. The range of the signal is always stated
as maximum in open space without obstacles and can be significantly affected by the
material of the building where it is used. The signal range also depends on the
location of the transmitter and the receiver.
• Avoid placing parts of the device near heat sources, areas with increased air
humidity, electromagnetic radiation, and large metal objects.

Operational information

You can use this wireless set of sockets right after unpacking and inserting the battery-
Receiver- socket: The socket can be plugged into any wall socket. The device, which will be
controlled wirelessly, mist be plugged into the wireless socket. The wirelessly controlled
device must always be switched on.

Remote control

Remove the battery compartment cover and insert one A23 battery. For each pair of buttons
no. 1, 2, 3, 4, 5, multiple sockets can be assigned. Each pair of buttons works independently.
The left/right side of the buttons turns ON/OFF the corresponding sockets. The ALL button
switches on or off all the sockets connected to the remote control. The red LED indicates the
signal transmission.