VALBERG 968179 Instructions For Use Manual page 23

B
Product usage
button
Control panel Remote control
Hold down for
2 – 3 s to access
the timer
• A beep will sound to confirm your selection whenever a button is pressed on the fan or
remote control.
• The current speed and status of the unit will appear on the display.
This button allows you to set the auto-on or auto-off timer from
"1" to "8" hours.
Timer
• To enter the timer setting mode, press the
/
press and hold the fan's
the icon starts flashing on the screen.
• Then press the
or decrease the duration (1-8 hours) in 1-hour intervals.
The hour values will loop when you press these buttons.
Once the desired duration is displayed on the screen, stop
pressing the buttons. The selected hour value and
will flash twice and your settings will be automatically
confirmed.
• Auto-on: The auto-on timer can be set when the unit is
in Standby mode. The speed and oscillation settings will
remain the same as defined during the previous use. Once
the timer has been set and confirmed, the screen will
display the duration and the
before turning off to save energy. Press any button (except
the button) to turn the display back on again.
Once the timer duration has elapsed, the unit will
automatically turn on.
• Auto-off: The auto-off timer can be set when the unit is
in use. Once the timer has been set and confirmed, the
screen will display the current speed and the
be steadily lit. Should the display turn off (for energy-saving
reasons), press any button (except the
back on. Tap the
Once the duration of the auto-off timer has elapsed, the
unit will stop and automatically switch to Standby mode.
• To cancel a programmed auto-on or auto-off:
– Press the
– Repeatedly press the
to "0" or
– press and hold the
repeatedly press the
returns to "0".
22
Function
button for 2-3 seconds until
/ / or buttons to increase
icon will be steadily lit
icon to check the set duration.
button.
button until the hour digit returns
button for 2 -3 seconds; then
button until the displayed time
EN
button or
icon
icon will
button) to turn it