Half-Tone Images Print Unevenly; Toner Smudges - Epson AcuLaser C4200DN User Manual

There may be no toner left in the
toner cartridge.
There may be a problem with the
photoconductor unit.

Half-tone images print unevenly

Cause
Your paper may be moist or damp.
There may be no toner left in the
toner cartridge.
The gradation setting is too small
when printing graphics.
There may be a problem with the
photoconductor unit.

Toner smudges

If the message on the LCD panel or in
EPSON Status Monitor indicates that the
amount of toner left is low, see"Toner
Cartridge" on page 312.
You can also check the remaining toner
with the following symbols on the Basic
Settings tab in the printer driver.
Toner low: !
Toner end: ×
Replace the photoconductor unit. See
"Photoconductor Unit" on page 318.
What to do
Do not store paper in a humid or damp
environment. Be sure to use paper that is
newly unwrapped.
If the message on the LCD panel or in
EPSON Status Monitor indicates that the
amount of toner is low, replace the toner
cartridge. See "Toner Cartridge" on page
312.
You can also check the remaining toner
with the following symbols on the Basic
Settings tab in the printer driver.
Toner low: !
Toner end: ×
On the Basic Setting menu in the printer
driver, click More Settings, select the
Enh.MG button, then select Smooth.
Replace the photoconductor unit. See
"Photoconductor Unit" on page 318.
Troubleshooting
11
11
11
11
11
N e w : F o r c o l o r p r o d u c t
11
11
11
11
11
11
11
N e w : v a r y a c c o r d i n g t o p r o d u c t ( e g . p h o t o c o n d u c t o r u n i t ) / d e l e t e u n n e c e s s a r y i n f o r m a t i o n
385