EEG LexiLocal Application Note page 13

Once logged in successfully, enter an access code configured in the LexiLocal system and click
"Connect" to monitor the access code. You can then:
Check if the encoder(s) assigned to this access code are currently connected to LexiLocal
•
by checking the "Encs" count on the lower center of the iCap window
Hear the audio feed from the encoder through speakers or headphones attached to
•
your computer. If the Audio Packets "blue bars" are present on the lower right, this
indicates that UDP audio packets are being received from the encoder, even if the
volume is low. If the blue bars are not displayed this indicates that the iCap software is
not receiving audio packets, possibly because the audio configuration on the encoder is
incorrect, the packets are being blocked through the network, or if the bars are only
partially full, there may be partial packet loss along the network path.
See live caption text through the system in the top box. You should see the same
•
caption text in this box that is currently being embedded in the video by the caption
encoder, whether those captions are sourced from Lexi Automatic Captioning, a
captioner, or were previously recorded on the video signal.
See a low frame rate live video of the encoder's input signal, with captions overlaid by
•
selecting "Window" | "Open Video" from the iCap menu.
Copyright © 2019 - 2020 EEG Enterprises, Inc.
pg. 13