Ivation IVAADSS25 - Stainless-Steel Wine Aerator & Dispenser Set Manual

• Keep product away from children. Make sure product is out of reach from children.
• Do not place product near an open flame, flammable gas, heating appliance, or a heated surface.
• Do not submerge the appliance in water or any other liquid.
• Do not use this appliance outdoors. This product was intended for indoor usage only.
• Do not use this product for anything except for its intended purpose.
• Do not attempt to open, alter, or change mechanisms within the appliance.
• Never force the product onto a wine bottle, nor should you attempt to speed up the mechanism. Using the product aggressively or recklessly can damage the appliance.
• This appliance should not be used by children or persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they are closely supervised at all times, and/or have received extensive instruction and training on how to use this device by a person responsible for their safety.
• Batteries are not included. When inserting batteries, make sure that the positive and negative polarities match with the markings in the compartment.
• Do not mix old and new batteries together.

1. Locate the lock and unlock symbols on the stainless-steel casing.
   
   
2. Twist the casing so the arrow is over the unlock symbol. Then, remove the casing to reveal the battery compartment.
   
   
3. Insert four (4) AAA batteries (not included) into the battery compartment. Then, place the casing back over the battery compartment and turn it so the arrow is over the lock symbol.
   
   NOTE: This product is suitable for wine bottles with a bottleneck outer diameter of no more than 1.4" (35 mm) and an inner diameter between 0.7" (17.5 mm) and 0.8" (19.5 mm). Make sure the dispenser is perfectly placed on the bottle, sealing the bottle opening completely so no air can escape. Failure to do so may cause the product to not operate properly.
4. Remove the cap on the bottom of the wine aerator/dispenser.
5. Attach the extension tube onto the bottom of the wine aerator/dispenser and adjust the tube to the desirable length.
   
   
6. Insert the extension tube into the wine bottle and make sure the wine aerator/dispenser is firmly placed on the bottleneck. To aerate your wine, switch the aerator valve to the "ON" position to enable the aeration function if needed. Dispenser can still be used effectively if the aerator valve remains in the "OFF" position.
7. Place a wine glass under the dispensing spout. Then, press and hold the dispensing button on top of the wine aerator/dispenser to let wine flow smoothly through the channel into the glass. When the dispensing button is pressed, the dispensing spout will light up indicating that the wine aerator/dispenser is in operation.
8. Release the dispensing button when finished pouring the wine.
   
   NOTE: When there is less than 50 ml of wine left in the bottle, it is recommended to switch off the aerator valve when wine is dispensing. Otherwise, the wine may spray out a bit through the aeration air inlet due to the air pressure change.

1. After using the aerator/dispenser, fill an empty wine bottle with clean water. Then, insert the extension tube and wine aerator/dispenser onto the bottle.
2. Press and hold the button to dispense the water and clean out the tube. Repeat this process at least three (3) times to effectively clean the aerator/dispenser.
3. Afterward, the extension tube can be removed from the aerator/ dispenser and washed with water directly.
4. Later, dry the product with a soft cloth after the cleaning. Then, store the aerator/dispenser in a clean, dry place when not in use.

• If the dispenser/aerator does not operate after pressing the dispensing button, check that the dispenser/aerator is firmly placed on the bottleneck and the extension tube is correctly connected to the dispenser/aerator.
• If the dispensing speed is slow, then battery power may be low. Please remove the old batteries from the dispenser/aerator and insert new, fresh ones into the device.

info@myivation.com
1-866-849-3049
IVATION is a trademark of C&A IP Holdings LLC, in the U.S., Canada, and the EU.
All other products, brand names, company names, and logos are trademarks of their respective owners, used merely to identify their respective products, and are not meant to connote any sponsorship, endorsement, or approval.
Distributed by C&A Marketing, Inc., 114 Tived Lane East, Edison, NJ 08837 Made in China.
© 2022. C&A IP Holdings LLC. All Rights Reserved.