Refilling Water - TERMOTEK P320-20240 Instruction Book

Version 1.1
6.3

Refilling water

The chiller indicates the water level with the water level display on the front panel. Should the
water level fall below the minimum, then the aquivalant message will be displayed. Should the
level fall further, below the minimum alarm level, then various components inside the chiller are
switched off (pump, compressor, heating). This condition is indicated by a red LED and a
corresponding message.
To refill water, proceed as follows:
1. Remove the cap from the filler pipe.
2. Gradually fill filtered (< 25 µm) water into the chiller via the filler pipe until the maximum
level is displayed.
Confirm the message with the quit – key (). The red LED switches off.
3.
4. Screw the cap back onto the filler pipe.
Phone: +49(0)7221/97 11-0 – Fax: +49(0)7221/97 11-111
Filler pipe and water level display
Im Rollfeld 6 76532 Baden-Baden, Germany
E-Mail: info@termotek.de - www.termotek.de
P300
25