產品參數 額定電壓 110V/60 Hz 總額定消耗電功率 120 W 抽氣時間 <15 s 真空封口時間 <35 s 單次封口時間 10 s 真空度 >50 kpa 最大封口寬度 300 mm 封口溫度 130℃ 吸力值 ≥4.5 L/min 封口線寬度 2-3 mm 產品尺寸 387×140×75mm 產 品淨重 0.97 kg 商品原產地 中國...
Page 10
1. Safety and matters needing attention………………....9 2. Product Features……………………………………………...10 3. The shape and structure of the product......11 4. Instructions for operation............12 5. Best operating guidance for vacuum bag sealer....13 6. Repair and maintenance............14 7. Common trouble shooting..........14 8. Comparative guide for vacuum preservation of food..15 9.
Page 11
12. Do not immerse the appliance in water. If wetted during the use, please use insulating gloves to remove the plug, and use dry clothes wipes ,and wait until it completely dry. 13. No lubricant or lubricating oil is required for the product, and an organic solvent is prohibited to be used for wiping.
Page 12
The shape and structure of the product 1. Buttons : 1) Soft 2) Normal 3) Seal 4) Stop 2. Indicate Light : 5) Soft indicator-Green 6) Normal indicator-Blue 7) Seal indicator-Red 3. Other parts : 10) Lower Gasket 8) Slide Bag Cutter 9) Lid Release button 11) Vacuum Chamber 12) Heating Seal 13) Sealing Rubber Strip...
Page 13
Instructions for operation 1. Release the cutter by pushing the right hand side of the cutter bar. Insert the vacuum bag at a desired length. (Figure 1) 2. Push down the cutter bar until you hear a big lock-up sound and cut the roll bag. (Figure 2) 3.
Page 14
Best operating guidance for vacuum bag sealer 1. Do not overfill bags: leave 8-10cm of empty space between the item to be packaged and the open end of the bag. 2. Clean and straighten the open end of the bag. Ensure there are no wrinkles, ripples, dust, food or liquid residue along the edge to be sealed.
Page 15
Repair and maintenance 1. Before cleaning the machine, make sure that the machine is powered off. 2. No part of the machine shall be immersed in liquid for cleaning. 3. Do not use a brush to wipe the body to avoid scratching the surface of the body. 4.
Page 16
6. The interval time between each continuous vacuum sealing should be 15 seconds and should rest 10 minutes after 20 times continuous normal dry vacuum sealing. 7. The interval time between each continuous vacuum sealing should be 15 seconds and should rest 10 minutes after 20 times continuous soft vacuum sealing.
Page 17
Product parameters Rated voltage 110V/60 Hz Rated power 120 W Pumping time <15 s Vacuum sealing time <35 s Single sealing time 10 s Vacuum degree >50 kpa Maximum sealing 300 mm width Sealing temperature 130℃ Suction value ≥4.5 L/min Sealing line width 2-3 mm Product size...
Need help?
Do you have a question about the TM-SAVA01M and is the answer not in the manual?
Questions and answers