Product Description - Nevir NVR-5502CSD User Instructions

English

Product Description

1. Temperature Control
3. 2x removable basket drawers
Before using for the first time
- Remove any exterior and interior packaging materials completely, including the adhesive
strips.
- Before it is connected to the mains, the unit must be thoroughly checked for transport
damage, including its power cord.
- Clean the unit as described in the section Maintenance and cleaning.
- To ensure proper functioning, wait for about two hours before connecting the unit and
switching it on after it has been positioned.
- When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Setting and selecting the freezer operating temperature
Operating for the first time
•
When operating under normal conditions and unloaded, auto mode usually stops at the
required temperature in 2 or 3 hours.
•
Then set the thermostat to the required setting for the freezer conditions.
Temperature control (Thermostat)
Caution:
do not attempt to turn it further or it will be damaged.
•
The temperature in the freezer is controlled by the thermostat control regulator in the
upper side of freezer. Turn the thermostat control regulator to regulate the temperature
inside the freezer. Use a wide flat bladed screwdriver or coin to adjust the temperature.
The markings on control regulator indicated "OFF, 1, 2, 3 and 4" for the different
temperature grades.
•
The closer the knob is set to position "3", the lower the temperature. A medium setting is
the most suitable for general operations.
•
Position "4" is colder than the position "1". The freezer temperature will vary depending
on the quantity of food stored and the frequency of door opening.
Important:
energy, we recommend you do not store too much food inside and do
not open the door too frequently.
When the thermostat is turned clockwise to position "4",
In order to maintain good cooling efficiency and save
6
2. Plastic flap
4. Door