Maintenance - Husqvarna 525iLST Operator's Manual

3. Push the stop button.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
WARNING:
you do maintenance.

Maintenance

Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the cutting attachment is not damaged. Replace the cutting
attachment if it is damaged.
Make sure that the cutting attachment guard is not damaged. Replace the cut-
ting attachment guard if it is damaged.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons on the battery works and locks the
battery in the product.
Examine that the battery charger is not damaged and function correctly.
Make sure that the battery is not damaged.
Make sure that the loop handle is not damaged and attached correctly.
16
Maintenance
Before you do any
Remove the battery before
4. Push the release buttons on the battery and pull the
battery out.
The following is a list of the maintenance steps that
you must do on the product. See
maintenance on page 11 for more information.
Safety instructions for
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
1920 - 001 - 28.11.2022