Continuity - Kane -VCT Instruction Manual

5. Continuity Test
Note: The continuity test is only possible when
batteries are installed & in good condition
The continuity test is only possible when
batteries are inserted & in good condition.
Ensure the circuit under test is not live.
Connect test probes L1 and L2 to the circuit. The
continuity LED (6) will illuminate & the buzzer will
sound.
The unit will indicate continuity below 400K ohm.
6. Phase Rotation Indication
Correct Phase Sequence
11
LED on
LED off
Phase Rotation Test
Rotary Phase of
Three-Phase Mains
LED on
LED off
6. Phase Rotation Indication (continued)
Perform a function test prior to this test.
This unit can determine the phase rotation within
a three phase supply.
Connect test probe L2 to the supposed phase
2 & the test probe L1 to the supposed phase 1.
If the R LED illuminates the phases are in the
correct sequence 1 to 2.
Connect test probe L2 to the supposed phase 3
& test probe L1 to the supposed phase 2.
If the R LED illuminates the phases are in the
correct sequence 2 to 3.
Connect test probe L2 to the supposed phase
1 & the test probe L1 to the supposed phase 3.
If the R LED illuminates the phases are in the
correct sequence 3 to 1.
During phase rotation test touch the contact
electrode.
If the L LED illuminates, then the phase sequence
is anti-clockwise.
12
LED on
LED off
Incorrect Phase
Sequence