Overview below, we declare under our sole responsibility that the product: Safety Notice III. Instrument Symbols KANE-VCT Technical Specification to which this declaration relates is in conformity Display & Controls with the relevant clauses of the following Operating Instructions standards:...
The meter has been designed in accordance standards. with the safety regulations for electronic The KANE-VCT is a fully automatic voltage indicator measuring instruments, EN 61010-1:2010, EN capable of measuring AC/DC voltage up to 690V. 61010-2-030:2010, EN 61010-031:2015, EN The KANE-VCT has visual &...
Caution! Dangerous voltage, potential risk of electrical shock. IV. KANE-VCT Specification Equipment protected throughout by KANE-VCT Voltage Indicator Specification double or reinforced insulation. Complies 2 Pole Voltage Indication with IEC 536, class II Voltage range...
LED (6) will be lit, & an audible tone should be heard. Before any test, check the unit on a known voltage source or approved voltage proving unit. If the unit is defective it should be put out of service & returned to KANE for repair.
3. DC Voltage Indication 4. Single Pole Voltage Indication LED on DC Voltage LED off For DC voltage measurement, connect probe Perform a function test prior to this test. L2 to the positive terminal & L1 to the negative terminal. The voltage is displayed on the LEDs This unit can be used as a single pole voltage &...
5. Continuity Test 6. Phase Rotation Indication (continued) LED on LED off Perform a function test prior to this test. This unit can determine the phase rotation within a three phase supply. Connect test probe L2 to the supposed phase 2 &...
Discharged batteries should be disposed of for a particular purpose, are limited to the express responsibly & with compliance with current warranty. KANE shall not be liable for loss of use of recycling & disposal regulations. the instrument or other incidental or consequential...