Table of Contents
Advertisement
Operation
・ Take care to ensure that power cable could not be pulled out or damaged during operation.
There is risk of fire or electric shock.
・ Do not place anything on the power cable. There is risk of fire or electric shock.
・ Do not touch(operate) the product with wet hands. There is risk of fire or electrical shock.
・ Do not place a heater or other appliances near the power cable. There is risk of fire and elec-
tric shock.
・ Do not allow water to run into electric parts. There is risk of fire, failure of the product, or elec-
tric shock.
・ Do not store or use flammable gas or combustibles near the product. There is risk of fire or
failure of product.
・ Do not use the product in a tightly closed space for a long time. Oxygen deficiency could
occur.
・ When flammable gas leaks, turn off the gas and open a window for ventilation before turn the
product on. Do not use the telephone or turn switches on or off. There is risk of explosion or
fire.
・ If strange sound, smell or smoke comes from product, turn the breaker off or disconnect the
power supply cable. There is risk of electric shock or fire.
・ Stop operation and close the window in storm or hurricane. If possible, remove the product
from the window before the hurricane arrives. There is risk of property damage, failure of
product or electric shock.
・ Do not open the inlet grill of the product during operation.(Do not touch the electrostatic filter,
if the unit is so equipped.) There is risk of physical injury, electric shock, or product failure.
・ When the product is soaked (flooded or submerged), contact an authorized service center.
There is risk of fire or electric shock.
・ Be cautious that water could not enter the product. There is risk of fire, electric shock, or
product damage.
・ Ventilate the product from time to time when operating it together with a stove, etc. There is
risk of fire or electric shock.
・ Turn the main power off when cleaning or maintaining the product. There is risk of electric
shock.
・ When the product is not be used for a long time or the product use first time after test run-
ning, turn on main power switch before 6hours ago.
・ Take care to ensure that nobody could step on or fall onto the outdoor unit. This could result
in personal injury and product damage.
・ Do not use means to accelerate the defrosting process or to clean, other than those recom-
mended by the manufacturer. (for R32)
・ Do not pierce or burn. (for R32)
・ Be aware that refrigerants may not contain an odour. (for R32)
・ When mechanical connectors are reused indoors, sealing parts shall be renewed.(for R32)
・ When flared joints are reused indoors, the flare part shall be re-fabricated.(for R32)
!
CAUTION
Installation
・
Always check for gas (refrigerant) leakage after installation or repair of product. Low refrigerant lev-
els may cause failure of product.
・
Install the drain hose to ensure that water is drained away properly. A bad connection may cause
water leakage.
・
Keep level even when installing the product. To avoid vibration or water leakage.
・
Do not install the product where the noise or hot air from the outdoor unit could damage the neigh-
borhoods. It may cause a problem for your neighbors.
・
Use two or more people to lift and transport the product. Avoid personal injury.
・
Do not install the product where it will be exposed to sea wind (salt spray) directly. It may cause cor-
rosion on the product. Corrosion, particularly on the condenser and evaporator fins, could cause
product malfunction or inefficient operation.
・The appliance shall be stored so as to prevent mechanical dam age from occurring. (for R32)
・Refrigerant tubing shall be protected or enclosed to avoid da mage. (for R32)
IMPORTANT SAFETY INSTRUCTIONS
5
Advertisement
Table of Contents
