Operation; Cool Mode - Polar Electro GE959 Instruction Manual

3. Extend the adjustable window kit as necessary,
then connect the exhaust hose to the window
kit.
4. Close the window to secure the kit in place. If
required, secure the window kit with duct tape.
It is recommended to seal off the gap between
the adapter and the sides of the window for
optimal efficiency.
5. Attach the hose connector to the exhaust air
outlet of the unit.
GE959_ML_A5_v1_20230104.indb 7 GE959_ML_A5_v1_20230104.indb 7
6. Adjust the length of the flexible exhaust hose,
and avoid bends in the hose.
7. Adjust the louver at the air outlet.

Operation

Tip: Unless otherwise stated, all the
buttons or indicators referred to in this
chapter mean those on the control panel.
Turn On/off
1. Connect the appliance to the mains power
supply. The appliance will enter Standby.
2. Turning on: Press the Power switch. The unit
will run with the Fan mode by default.
3. Press the Mode selection key repeatedly to
select desired operation mode.
4. Turning off: After use, press the Power switch
to turn the appliance off. The appliance will
enter Standby again.

Cool mode

Select this mode to lower the temperature in your
room.
1. Press Mode button until the COOL mode
indicator lights up.
2. Press Up/Down buttons to set temperature.
3. Press Speed button repeatedly to select the
desired fan speed.
4. If desired, press Swing button to activate the
swing function.
Note: The appliance will stop if the room
temperature is lower than the set temperature.
EN
7
2023/1/4 17:37:20 2023/1/4 17:37:20