Subscribe to Our Youtube Channel
Related Manuals for Edwards nEXT 730
Summary of Contents for Edwards nEXT 730
- Page 1 730/930D/1230H Air Cooler INSTRUCTION MANUAL B8J202880_C Original instructions 300872818_002_C2...
- Page 2 Copyright notice ©Edwards Limited 2021. All rights reserved. Trademark credit Edwards and the Edwards logo are trademarks of Edwards Limited, Innovation Drive, Burgess Hill, West Sussex RH15 9TW. Disclaimer The content of this manual may change from time to time without notice. We accept no liability for any errors that may appear in this manual nor do we make any expressed or implied warranties regarding the content.
-
Page 3: Table Of Contents
2. Installation and operation........6 B8J202880_C Page 3 03/2021 - ©Edwards Limited 300872818_002_C2... -
Page 4: Description
B8J202880_C - Description 1. Description The air cooling unit cools the nEXT 730/930D/1230H turbomolecular pumps. Refer to the pump operating instructions for information about which pumps the air cooling unit can be connected to. Do not fit the air cooling unit to other pumps. Do not operate the air cooling unit if it has not been correctly fitted. -
Page 5: Ordering Data
B8J202880_C - Description 1.3 Ordering data Air cooling for nEXT 730/930D B8J200800 Air cooling for nEXT 1230H B8J200801 Figure 2 Dimensions in mm Air cooling for nEXT 730/930D nEXT 1230H B8J202880_C Page 5 03/2021 - ©Edwards Limited 300872818_002_C2... -
Page 6: Installation And Operation
The accessory connection is pre-configured so that the air cooling is always running when the pump is running. To change this setting, refer to the pump instructions. Figure 3 Example for mounting of an air cooling B8J202880_C Page 6 03/2021 - ©Edwards Limited 300872818_002_C2... - Page 7 EU Declaration of Conformity Edwards Ltd Innovation Drive Burgess Hill West Sussex RH15 9TW Declare that the following product Air cooler for Turbomolecular Pumps B8J200800 B8J200801 Is in conformity with the relevant requirements of European CE legislation: 2006/42/EC Machinery directive Note: The safety objectives of the Low Voltage Directive 2014/35/EU were complied with in accordance with Appendix 1 No.
- Page 8 Additional Legislation and Compliance Information EU EMC Directive: Class A/B Industrial equipment Caution: This equipment is not intended for use in residential environments and may not provide adequate protection to radio reception in such environments. EU REACH Regulation Compliance This product is a complex article which is not designed for intentional substance release. To the best of our knowledge the materials used comply with the requirements of REACH.
- Page 9 This page has been intentionally left blank.
- Page 10 edwardsvacuum.com...
Need help?
Do you have a question about the nEXT 730 and is the answer not in the manual?
Questions and answers