Louroe Electronics MS-D1 Installation And Operating Instructions

6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
techsupport@louroe.com
DESCRIPTION
The MS-D1 Mute Switch is an accessory for all Louroe Digifact Audio Monitoring/Audio Surveillance Systems when
microphone muting is required remotely from any Digifact hardware with a microphone. The MS-D1 contains a built-in
rocker switch with a Green L.E.D. mounted to a single gang stainless steel face plate. It is easy to setup in any
environment using 2 pairs of Cat5e or Cat6 cabling. The MS-D1 is used to mute or disable the audio feed to any
Digifact E hardware. It disables the audio stream from processing audio in the Digifact hardware, which prevents the
operator from listening in to the microphone. The MS-D1 fits into a single gang back box (not included) for mounting, on
a flat surface or in a wall.
OPERATION
Login to the Louroe's Digifact Software Portal interface for the Digifact hardware you want to add Audio Muting too.
Select the following settings from the (Output Settings Tab), 1.) Select Trigger Source and set it to (Input 1), 2.)
Select Output Port, set it to (Digital Mute). When finished, disconnect the RJ45 cable to your Digifact Hardware, set
the MS-D1 switch to the OFF position. Follow the wiring Diagram 1A. on page 2 for all wiring connectivity between the
MS-D1 digital controlled mute switch and your Digifact hardware. Testing: 1.) Reconnect the RJ45 cable and wait for
the Digifact hardware to power-up, now set the MS-D1 to the on position, the Green L.E.D. should turn on indicating
the Digifact hardware audio stream is muted.
WIRING REQUIREMENTS
Requires Cat5e or Cat6 Cabling,
(Not Included). See wiring
CONNECTIVITY on Page 2.
Please Note!
All specifications are subject to change without notice.
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX
®
INSTALLATION AND OPERATING INSTRUCTIONS
/ www.louroe.com
MODEL MS-D1
The MS-D1 works with all DIGIFACT Hardware
®
website: www.louroe.com
MS-D1, Part No. LE-831
Digital Controlled (Analog Audio) MUTE SWITCH
R
SPECIFICATIONS OF MS-D1 MUTE SWITCH
Switch Contact
Digital Output Voltage
UTP, Cat5e, Cat6 Distance
Dimensions
Faceplate Material
Backbox
Weight
Shipping Weight
Package Includes:
1 x Single Gang Stainless Steel Wall Plate with a On/Off
Rocker Switch and Green L.E.D..
2 X Stainless Steel Screws
2 X Audio Monitoring On These Premises Stickers
e-mail: sales@louroe.com
Page 1 of 2
DIGIFACT TECHNOLOGY
R
5A @125Vac
5Vdc
Up to100 ft.
2 ¾ W x " 4 ½" H
303 Stainless Steel
Single gang electrical
box (not included)
2.5 oz
1 lb
LE-831-01272023-WB
(818) 994-6458