Operation; Control Panel - Rinnai Airo AAP240 Operation & Installation Manual

Table of Contents

Advertisement

CONTROL PANEL

@
Timer
Timer key
ON/OFF
SPEED
AUTO
TIMER
The built-in timer for the filter reset is 1500 hours operating hours. It is recommend that you change the
filter in 6 months. The filter life may vary depending on environment conditions.
IMPORTANT
Airo
8
-- -- --
1�, 1�, 1�1
1�, 1�, 1�,
I
r -'
' 1 --
Auto
Filter Reset -
Numerical
Auto key
display
On/Offbutton
Press "On/Off" button to Turn the appliance "On" or "Off".
Speed button
Press "Speed" to set the fan speed (Low, Medium or High).
Press once, 1 shown on the screen means Low fan speed;
Press twice, 2 shown on the screen means Medium fan speed;
Press three times, 3 shown on the screen means High fan speed.
Press speed button four times, blank on screen and the appliance work on low
fan speed which is suitable for sleep period.
NOTE
Displayscreen
Display Air quality level -
Smaller number means lower PM2.5 level and better air quality.
Display Colour of light bar –
Blue: Excellent air quality; Green: Good air quality; Red: Poor air quality.
Auto Button
Press "Auto" button to turn Auto mode.
In this mode, the appliance determines the air quality and display Air quality level on the
screen.
Fan speed is adjusted automatically based on the air quality.
Timer
With the appliance "ON", press the "Timer" button once to active Delay Off Timer.
Press "Timer" to set the desired time period 01h ~ 08h, up to 8 hours.
Filter Reset
The appliance has built-in timer to notify when to replace Filter. When filter needs to be
replaced, 'End' is displayed on the screen.
Once the filter is replaced, press and hold "Timer" and "Auto" button for 3 seconds
simultaneously.
®
Speed
I
Air quality
speed key
indicator
*
Power was displayed
7

OPERATION

@
On/Off
I
Power key
Air Purifier OIM

Advertisement

Table of Contents
loading

Table of Contents