Tiger SF-2200 Operating Instructions

Brake Winch Operating Instructions
WARNING: BEFORE USING THE WINCH, READ CAREFULLY
THIS MANUAL AND KEEP IT FOR FUTURE NEEDS.

(A) SPECIFICATIONS

Capacity Hand force
(lbs / kg) required(kg)
2200 / 1000 10

(B) FEATURES

A high quality, multi-purpose winch. SF-2200 adopt ratchet-type handle design. The ratchet
handle permits reciprocating handle movement in both directions for lifting and lowering
loads and accommodates installation in cramped locations such as wall and floor.
Automatic brake the ensures suspension of the load.

(C) USE

Lifting of the load must happen by set change lever in UP position then rotating the handle
clock-wise or operate handle back and forth to move load in up direction. When releasing
the handle, the load remains suspended. The descent of the load must happen by set change
lever in DOWN position then rotating the handle counterclock-wise or operate handle back
and forth to move load in down direction.

(D) IMPORTANT SAFETY INFORMATION

This winch is not used to transport people or for loads over areas where people could
●
be present.
Never apply load on winch with cable fully extended. Keep at least three full turns of
●
cable on the reel.
Operate with hand power and with crank included in the equipment only. This winch
●
should not be operated with a motor of any kind. If the winch cannot be cranked easily
with one hand, it is probably over-loaded.

(E) NOTE

The winch finish can be protected and will provide longer service if it is periodically washed
with water and then wiped with light oil or wax.

(F) LUBRICATION

The gear box of this winch has been fully lubricated and sealed with gear cover at the factory.
It is not necessary to grease gears after use.

(G) CAUTION

Do not oil or grease brake mechanism.
Model: SF-2200
Hub Diameter
Gear ratio
(mm)
22.2 : 1 80
Ø
Handle length Unit weight
(mm) (kg)
300 16
Cable diameter Cable storage
(mm/inch) cap.(m)
8.0 / 5/16 25
Ø Ø