Configuration Of The Network Adapter - Settings - Macherey-Nagel 162735 Instructions For Installation Manual

4. Configuration of the Network Adapter – settings
The following setup is required to run the installation of the Network Adapter:
Laptop or PC
Required items:

An Ethernet interface at the computer used for configuration

An Ethernet cable (CAT5E)

a Windows PC

Browser (recommended Google Chrome or Firefox)

Network Adapter (this product)
For the configuration of the Network Adapter settings connect the instrument directly or via a switch to a configuration PC with
an Ethernet cable (CAT5E).
For the connection use interface eth1 (see Pic.2)
The availability of the Network Adapter in the network can be checked via a ping to the IP address
192.168.2.1. The PC used for the configuration must have an IP address in the range 192.168.2.0/24.
Changing the IP address may be necessary to avoid conflicts between addresses within the setup.
Please ask your IT department for support.
LAN1
Pic.2: Ethernet interfaces
NOTICE
NOTICE
Network Adapter
LAN1 (eth1)
4/21