Troubleshooting (Q&A) - Sabik Marine SCLO 200M Product Manual

8. Troubleshooting (Q&A)
Q: I covered the photocell, but the lantern does not turn on.
A1: Read controller values with the programmer and check status. The battery voltage is below the
minimum programmed value. Replace the battery.
A2: The dated shut-down feature may be enabled. Re-programme to disable shut-down feature
A3: Read controller values with the programmer and check status. The day light sensor setting or read
value is abnormal. Re-programme if setting is wrong. Return the lantern for service if the read
value is wrong.
A4: Read controller values with the programmer and check status. There is a LED failure error. Return
the lantern for service.
Q: I covered the photocell, but the lantern does not turn on and I cannot read controller values with the
programmer.
A: Check the battery cables for damage or short-circuit. Replace the battery.
Q: I covered the photocell, but the lantern does not turn on and I cannot read controller values with the
programmer even though I replaced the battery.
A: Return the lantern for service.
Q: The lantern seems to work normally, but I cannot read it with the programmer.
A1: Locate the IR eye on your programmer and on the lantern. Place them facing each other.
A2: Try to shade out the sun and put the programmer close to the lens during read process.
A3: Try different angles when reading, the light beam might block out the IR sensor.
Q: There is moisture inside the lantern. Where is the leakage?
A1: Check that the PTFE vent is free and not blocked with bird droppings, which might prevent the
lantern from breathing. Replace the vent if required.
A2: Return the lantern for service – the light unit should not be opened in field conditions and attempts
to repair should not be undertaken unless appropriate product training has been obtained.
SCLO 200M
Date: Dec 23.2020 Version 1.03  Public version  Product Manual  21 of 24
SABIK Oy · BOX19 · FI 06151 Porvoo · Telephone +358 -19- 560 1100 · www.sabik.com