Advertisement
2
SPARROW
®
RCbro
User-Manual
2
SPARROW
Manual v2.0
Description
SPARROW
SPARROW 2
On the basis of the
FC,
has updated the operation
mode to simplify the user's use and enhance the operation experience. At the
same time, it adds support for a variety of receiver signals, including
PWM,PPM,SBUS,IBUS,CRSF and supports DJI-OSD,CRSF-TELE. For specific
functions and usage, refer to the detailed description below.
LefeiRC
www.lefeirc.com/
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for RCbro SPARROW 2
Summary of Contents for RCbro SPARROW 2
- Page 1 SPARROW Manual v2.0 Description SPARROW SPARROW 2 On the basis of the has updated the operation mode to simplify the user's use and enhance the operation experience. At the same time, it adds support for a variety of receiver signals, including PWM,PPM,SBUS,IBUS,CRSF and supports DJI-OSD,CRSF-TELE.
- Page 2 SPARROW ® RCbro User-Manual WARNING Please strictly abide by relevant national laws and regulations and fly safely. Before using the FC, you must fully understand the safety details. The equipment and any electronic products on the aircraft cannot be completely reliable. The necessary inspections must be carefully performed before the flight.
- Page 3 SPARROW ® RCbro User-Manual 1. PARAMRTER Size 33*27*12mm Weight Voltage Size 18*18*6mm Weight Voltage Receiver Type PWM,PPM,SBUS,IBUS,CRSF(ELRS) Accessories FC,GPS,Screwdriver,Wire Others Protocol DJI-OSD,CRSF-TELE 2. INSTALLATION & WIRING ➢ FC Installation Direction ➢ Interface LefeiRC www.lefeirc.com/...
- Page 4 SPARROW ® RCbro User-Manual Servo RC CH6 or CH7 output CH1-4 PWM-IN,CH1-4:AIL,ELE,THR,RUD Receiver PPM,SBUS,IBUS,CRSF or PWM Mode Channel CRSF-TELE Refer to the schematic diagram to connect *It is recommended to select the 3-switch as a mode channel. *It supports 5-channel PWM input, so when using PWM receiver, the AUX cannot be used.
- Page 5 SPARROW ® RCbro User-Manual ➢ CRSF-TELE 3. REMOTE CONTROL ➢ How to judge whether the RC is normal? After the PC is powered on, all the LEDs are on, and the GPS configuration starts. The 3 green lights flash at the same time, indicating that the GPS configuration is completed, and the RC is not recognized;...
- Page 6 SPARROW ® RCbro User-Manual Step 3: Push the throttle to the lowest position, the green light starts to indicate the type of plane and flight mode. ➢ How to use the FC to calibrate the ESC? Step 1: Push the throttle to the highest position in MANUAL mode;...
- Page 7 SPARROW ® RCbro User-Manual ➢ How to set the RC direction? *If the control direction is not correct, you can set the channel output reverse in the RC. ➢ FailSafe Type Setting method Set the mode channel output in the RC to ensure that the flight IBUS mode is RTH after the RC is turned off.
- Page 8 SPARROW ® RCbro User-Manual 5. FLIGHTMODE MODE Describe Green LED MANUAL RC directly controls the aircraft Slow Flash STABILIZATION Auto level ALTHOLD(NO GPS) Plane holds altitude, 25m minimum height limit Fast Flash RTH(GPS OK) Return to home. Circle within a radius of 50 m at an altitude of 70 m,13m/s...
Need help?
Do you have a question about the SPARROW 2 and is the answer not in the manual?
Questions and answers