Table of Contents
Advertisement
T I R E P R E S S U R E , P O W E R , B AT T E RY
TIRE PRESSURE
Pump tires to desired pressure. The range for the tires is from 5 psi to 30 psi, with 5 psi being the lowest
the tire is rated for. Lower pressures can provide more traction, however increase the risk of pinch flats,
and decrease the range of the motor. Higher pressures can decrease the possibility of pinch flats, but
also can decrease grip on softer and varied terrain. We recommend using a 2 psi difference between the
front tire and rear tire (+2 psi in the rear tire) to maximize traction in the front and stability in the rear, for
example 15 psi front, 17 psi rear.
5-15 PSI
15-25 PSI
for very soft sand
for most off-road riding,
or snow
depending on terrain
If you are riding in an area with a lot of thorns, we recommend puncture proof tire liners and/or a
tube/tire sealant.
POWERING THE UNIT ON
1. Make sure the battery is fully inserted and locked on your bike.
2. Get on the eBike, ready to ride.
3. Turn the battery on using the power switch
the ebike. (Storm model only. Skip to step 4 otherwise.)
4. Press and hold the power button
on the keypad for
a couple seconds until the display turns on.
5. When the power comes on, the power level will be set to 1,
and therefore engaged for throttle or pedal assistance.
6. Use the + or - key on the keypad to change your pedal
assist power level from 0-5 (0 is no assistance,
5 is maximum assistance).
7.
Press and hold (-) key for walk-assist mode.
8. Hold (+) key for 2 seconds for Sport Mode. This makes
the torque sensor more aggressive.
9. Hold (+) key again for Eco Mode. This will increase
battery efficiency.
10. To turn off, press and hold the power button
for a couple seconds.
6
25-30 PSI
for pavement or hard,
smooth surfaces
PEDAL-ASSIST POWER UP
HEADLIGHT ON/OFF
on top of
(I) INFORMATION
again
PEDAL-ASSIST POWER DOWN
DISPLAY SCREEN FOR STORM, MULE AND SCOUT
FI VE BUTTO N KEY PAD
Power Button: Turns power and display on and off
(+) Button: Increase power
(–) Button: Decrease power
Light Button: Turns on/off headlight if one is installed
(i) Button: Scrolls through information screens on the
Analyst Display. Quickly double click to view settings
and information.
ANALY ST DISPLAY
Current Speed
Trip Distance
Power Level
DISPLAY SCREEN FOR FLATLANDER
FO UR BUTTO N K EYPAD
Power Button: Bottom Right Button
(+) Button: Increase power
POWER ON/OFF
(–) Button: Decrease power
Press and hold (+) to turn light on/off
Press and hold (-) key for walk-assist mode.
ANALY ST DISPLAY
Current Speed
Trip Distance
Pedal Assist Level
Total Distance
Battery Level
Watts Output
Total Distance
Battery Level
Watts Output
MODE
POWER
UP
DOWN
7
VISIT US AT BAKCOU.COM |
Advertisement
Table of Contents
