Firstech, LLC. CM6000 Installation Manual page 20

Alarm and Starter System
www.firstechonline.com | www.compustar.com
CM6000 Install Guide
Connector 6 (CN6), 4-Pin (RS 232 Data Port)
This connector is used for updating control modules via www.firstechonline.com. You must also use this
port to flash Blade bypass modules. This port provides simple connectivity of Fortin and iDataLink bypass
modules.
This port is also used to communicate with DroneMobile controllers. Make sure to use the data port from
the DroneMobile unit to this RS232 port.
Connector 7 (CN7), 3-Pin (Pre-wired Valet/Programming Switch)
Pin 1 Gray/Black - Negative (-) ground.
Pin 2 Gray – 3V positive (+) L.E.D. output.
Pin 3 Gray – Negative (-) output.
Connector 8 (CN8), 2-Pin (Pre-wired Thermister)
Plug optional thermister into this connector to monitor the vehicle's temperature. It used in conjunction with
Timer Start features along with displaying temperature on two-way LCD's. To use Timer Start features review
Option Group 2. IMPORTANT: Thermister plugs are blue 2 pin connectors on the CM6 series but old
white plug Thermisters will still work.
Pin 1 Black - Thermister
Pin 2 Black/White - Thermister
Connector 9 (CN9), 4-Pin to 4-Pin or 6-Pin (Pre-wired Antenna Cable)
Connect your antenna cable to this port. You can only use 4 to 4 pin or 4 to 6 pin antenna cables. 6 to 6
Pin antenna cables do not work. Do not use both Connector 9 and Connector 10 at the same time.
Pin 1 Yellow - RX input. This wire receives the signal from remote.
Pin 2 White - TX output. This wire transmits the signal to remote.
Pin 3 Red - Constant 12V positive (+) output.
Pin 4 Black - Ground
Copyright 2011 Firstech, LLC. Page 20