Table of Contents
Advertisement
10 www.electrolux.com
When selecting "
controller, temperature indicator on indoor unit
displays set temperature.
When selecting "
perature indicator on indoor unit displays indoor
ambient temperature.
When selecting "
temperature indicator on indoor unit displays
outdoor ambient temperature.
NOTE
Outdoor temperature display is not available for some
models. At that time, indoor unit receives "
while it displays indoor set temperature.
It's defaulted to display set temperature when turning
on the unit.There is no display in the remote control-
ler.
Only for the models whose indoor unit has dual-8
display.
When selecting displaying of indoor or outdoor ambient
temperature, indoor temperature indicator displays
corresponding temperature and automatically turn to
display set temperature after three or five seconds.
3.4 Function introduction for
combination buttons
Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK"
buttons simultaneously to start up or turn off ener-
gy-saving function. When energy-saving function
is started up, "SE" will be shown on remote con-
troller, and air conditioner will adjust the set tem-
perature automatically according to ex-factory
setting to reach to the best energy-saving effect.
Press "TEMP" and "CLOCK" buttons simultane-
ously again to exit energy-saving function.
NOTE
Under energy-saving function, fan speed is defaulted
at auto speed and it can
Under energy-saving function, set temperature can
be adjusted. Press "TURBO" button and the remote
'
controller won
t send signal.
Sleep function and energy-saving function can
ate at the same time. If energy-saving function has
been set under cool mode, press "SLEEP" button will
cancel energy-saving function. If sleep function has
been set under cool mode, start up the energy-saving
function will cancel sleep function.
" or no display with remote
" with remote controller, tem -
" with remote controller,
" signal,
'
t be adjusted.
8
Under heat mode, press "TEMP" and "CLOCK"
buttons simultaneously to start up or turn off 8
heating function. When this function is started up,
"
" and "8 " will be shown on remote controller,
and the air conditioner keep the heating status at
8 . Press "TEMP" and "CLOCK" buttons simulta-
neously again to exit 8
NOTE
Under 8
auto speed and it can
Under 8
adjusted. Press "TURBO" button and the remote
controller won
Sleep function and 8
at the same time. If 8
under heat mode, press "SLEEP" button will cancel 8
heating function. If sleep function has been set under
heat mode, start up the 8
cancel sleep function.
Under
will display 46
Child lock function
Press "
turn off child lock function. When child lock func-
tion is on, "
ler. If you operate the remote controller, the "
icon will blink three times without sending signal to
the unit.
Temperature display switchover function
Under OFF status, press " " and "MODE" buttons
simultaneously to switch temperature display
between
WiFi function (some units)
Press "MODE" and "TURBO" button simultane-
ously to turn on or turn off WiFi function. When
'
t
WiFi function is turned on, the "WiFi" icon will be
displayed on remote controller; Long press
'
"MODE" and "TURBO" buttons simultaneously for
t oper-
10s, remote controller will send WiFi reset code
and then the WiFi function will be turned on. WiFi
function is defaulted ON after energization of the
remote controller. (This function only applicable for
some models)
heating function
heating function.
heating function, fan speed is defaulted at
'
t be adjusted.
heating function, set temperature can
'
t send signal.
heating function can
heating function has been set
temperature display, the remote controller
heating.
" and "
" simultaneously to turn on or
" icon is displayed on remote control-
and
.
'
t be
'
t operate
heating function will
"
Advertisement
Table of Contents
