Wasp CLAY Original Instructions Manual page 4

INTRODUCTION
The Continuous Feeding encompasses many technological innovations in the world of digital ceramics developed
by WASP.
The Manufacturer declines any responsibility for accidental damages caused by products when non-correctly
used.
WASP certifies the use of CONTINUOUS FEEDING SYSTEM with ceramic materials, in case of use of the system
with different kind of materials, warranty and support may not be valid anymore.
WARNING
-Read accurately the instructions before the use
-Before any intervention in proximity or inside the mixing area, shut the machine by pushing the red switch on the
front panel.
-Always keep the inspection door located on the left of the machine clean, in order to avoid the wrong closure of
it.
-Do not introduce or lay hands or other parts of the body in proximity of the moving parts.
-Keep far from the presence of children.
-Make sure every fan is working while the machine is turned on.
-Make sure that the extruder is not clogged.
-Do not put fingers inside the horizontal pipe while the machine is running.
-Do not eat the extruded materials.
-Make sure that the pipe between the extruder and the feeder do not present any deformation.
-Verify there are no leaks between threaded hose and pipes
-Do not replace parts if not original and supplied by Manufacturer
-Only properly formed staff can use the machine
-Make sure the material you're leaving inside the machine is not going to get dry until the next usage
-Make sure there are no debris inside the material, who can clog the feeder
-Periodically check for the wear of the moving parts.
-Do not remove any safety device covering the moving parts
-In case of prolonged inactivity the system must be cleaned carefully
© WASP S.r.l.
4