Lakeland Mills CF1009 Quick Start Manual

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the
store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly
for you.
TETE-A-TETE PORCH SWING COMPONANTS
2 - Preassembled Seat Backs
Right Left
Preassembled Swing Seat
2 - 24" Arms 2 - 21-1/2"Seat Ends
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered de-
fects.
Read all instructions before starting

Helpful Tips:
To start hex washer head screws, hammer into

wood about 1/2" then use wrench or socket to
tighten.
Do not completely tighten any screws until the unit

is fully assembled and setting on a level surface.
If you have hardware left over after completing

your unit, it most likely has been assembled incor-
rectly, and may not be safe to use. Please call
Customer Service at 1-800-427-5136, for assis-
tance.
A battery operated or electric drill will make as-

sembly faster and easier.
Use a good quality penetrating oil or wood deck

sealer with a UV inhibitor & an anti-fungal. (Make
sure product is intended for outdoor use.)
If staining or finishing before assembling, tape off

all dowel ends. (Finishes will cause the dowels to
swell, making assembly difficult
Check all nuts and bolts for tightness before

and during each usage season.
CF1009 TETE-A-TETE PORCH SWING
2 - 45" Swing
Table Top Bars
2 - 9-1/2" Front
Table Supports
2 - 12"
Arm Supports
.
"
TETE-A-TETE PORCH SWING HARDWARE
4 - 1/4" x 5" 2 - S Hooks
Hex Washer
Head Screw*
18 - 2 1/2" Screws
* Lag Screws and Washers may be substituted for Hex Washer
Head Screws
TOOLS REQUIRED
Rubber Mallet or Block
of Wood & Hammer
NOTE: Using a battery
Or electric power drill with a socket
assembly easier and faster.
Install seat ends onto seat. Align holes in seat end with
STEP 1
dowels on seat . Repeat on other side. Secure with screws
perpendicular to dowel. IMPORTANT: The single hole
should be placed toward the front of the seat. (See right).
Figure 1. Secure with screws.
Please Note: After you have installed the seat ends onto the seat
secure with (4) 2 1/2" screws.
2 - 3/8" x 5" Eye Bolts
2 - 3/8"
Washers
#2 Phillips Screw-
7/16 Socket or Wrench
driver & Regular
Screwdriver
Tape
Measure
Pencil
attachment
will make
Figure 1
2 - Barrel
Nuts