Lakeland Mills Cedar Log Single Chair Porch Swing CF26 Manual

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to
the store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems
directly for you.
PORCH SWING COMPONENTS
2 Arms 24" Long
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
Rubber Block of Wood
Mallet & hammer
or
NOTE
Read all instructions before starting.

To start hex washer head screws, hammer into wood about
1/2", then use wrench to tighten.

Do not completely tighten any screws until the unit is fully
assembled and setting on a level surface.

Use a rubber mallet (or block of wood between the hammer
and the unit) to drive doweled ends into holes as far as possi-
ble.

A battery or power screw gun will make assembly easier
and quicker.
CF26 SINGLE CHAIR LOG PORCH SWING
Preassembled Swing
Seat
2 Arm Supports
12" Long
2 - 21"
Seat Ends
TOOLS REQUIRED
7/16
Socket
7/16"
wrench
Phillips
Screwdriver
or
or
Tape Measure
Pencil
or Marker
2 - Swing
PORCH SWING HARDWARE
Bars - 45"
(Shown smaller than actual size)
Two S Hooks
Two 3/8" x 5"
Eye Bolts
# 2
Regular
Screwdriver
STEP 1
Install seat ends
onto seat. Align holes in
seat end with dowels on
seat as shown in picture at
right. Repeat on other side.
Secure with screws perpen-
dicular to dowel. IMPOR-
TANT: The single hold
should be place toward the
front of the seat.
or
*Four 1/4" x 5" Hex
Washer Head
Two 3/8"Washers
Ten Screws
Two Barrel
Nuts
Hex Washer Head Screws may require:

9/16" wrench

7/16" wrench

3/8" wrench
* Lag screws and washers may be substi-
tuted for Hex Washer Head Screws.
Please Note: After you have
installed the seat ends onto the
seat, secure with (4) 2 1/2"
screws. See figures at left.
Screws
front