Case Dulwich Quick Start Manual

Round extending table

Care Instructions

Dulwich Round Extending Table – designed by Matthew Hilton

To prolong the life of the product and retain its appearance and functionality,

we would like to give you some relevant information and care advice:-

This unit is manufactured with either oak, black stained oak or walnut.

Craftsmen manufacture this product and there is variety between each unit. This is

because wood is a natural product, with natural colour and grain variations.

Natural timber is affected by sunlight; this can can the wood colour to darken.

For this reason (especially if placed in direct sunlight) it is recommended that placing

objects in the same position for long periods of time is avoided. This potential colour

adjustment becomes less relevent as the product ages.

Note that if the extension leaf is stored inside the table for long periods without

exposure to light, the natural richening of the wood will be limited. This will cause the

leaf to appear lighter than the rest of the table until it has been exposed to a similar

level of sunlight.

It is recommended that no abrasive cleaners or solvents are used to clean the unit.

Please only use proprietary furniture polishes or alternatively, warm water with

a diluted mild detergent.

We thank you for purchasing this product and wish you many years of enjoyable and

functional use.

For more related products please visit: casefurniture.com

Case Furniture Ltd

London, SW18 2HZ

United Kingdom

info@casefurniture.com

casefurniture.com

Dulwich

Round Extending Table

Table of Contents

Do you have a question about the Dulwich and is the answer not in the manual?

Page 1 Dulwich Care Instructions Round Extending Table Dulwich Round Extending Table – designed by Matthew Hilton To prolong the life of the product and retain its appearance and functionality, we would like to give you some relevant information and care advice:- This unit is manufactured with either oak, black stained oak or walnut.
Page 2 Assembly Instructions Fig. 1 1. Unpack all components and allow ample room for assembly and turning. 2. Take dowels (D) and insert them into the holes shown on the underframe. 3. Take one leg and push onto the dowels. 4. Fasten each leg to the underframe using 1 x bolt (B) and 1 x bolt (C) and allen key (A).