Advertisement
Quick Links
Advertisement
Related Manuals for AYVAZ SK-50
Summary of Contents for AYVAZ SK-50
- Page 1 SK-50 SK-50B USER MANUAL FLOAT TYPE STEAM TRAP SK-50/ SK-50B...
- Page 2 FIRE DANGER Warning danger of fire! HOT SURFACE Warning risk of hot surface! © 06/2020 Hacı Ayvaz Endüstriyel Mamuller Sanayi ve Ticaret A.Ş. All Rights Reserved. AYVAZ® is a registered trademark. Please read this manual before you start using it!
-
Page 3: Table Of Contents
SK-50 CONTENT PAGE TITLE General Information General Features Safety and Environmental Instructions Transport, Packaging and Storage Installation Operation Maintenance and Cleaning Disassembly, Maintenance and Cut-out Technical Drawing... -
Page 4: General Information
Before the maintenance, be careful of the temperature on the line. lt can cause some physical injuries. Please wait unlil the temperature decrease to nominal level. 2.2 GENERAL PRODUCT INFORMATION SK-50 product is a float trap with air discharge unit. Air discharge unit can be thermostatic capsule or bimetallic element as an optional. - Page 5 Signs should be placed where the fluid temperature is 60 ° C and above. The item must be operated in accordance with the general safety instructions listed above. Ayvaz cannot be held responsible for problems arising from use that does not comply with the safety instructions.
-
Page 6: Transport, Packaging And Storage
SK-50 3.4 Responsibility of the User This item is a commercial product. Therefore, the user is responsible for legal obligations related to occupational safety. Along with the safety instructions specified in this user manual; accident prevention measures and environmental protection laws must be considered. -
Page 7: Installation
SK-50 5. INSTALLATION Before the installation, you should read safety instructions carefully. a- Check the label and technical information sheet if the product is suitable for the required installation. b-Check the maximum pressure and temperature values. lf the pressure in the system is higher than the maximum value of the product, provide the use of safety tools in order to prevent the excess pressure. - Page 8 SK-50 7. MAINTENANCE & CLEANING 7.1 Maintenance Before carrying out any operation on the trap, the trap should be isolated from the supply line and return line and the pressure in the system should be relieved safely. Then the trap should be allowed to cool. When reassembling the system, ensure that all connection surfaces are clean.
-
Page 9: Maintenance And Cut-Out
SK-50 8. DISASSEMBLY, MAINTENANCE AND CUT-OUT Fluid that can cause physical injury, product damage and environmental damage. · Carefully clean the dismantled item to eliminate physical injuries, fluid damage, and damage to the environment. 8.1 Disassembly If there are closing valves, remove the item safely after closing the closing valves. If there is not closing valve, remove only the item to be disassembled on the tank when the system pressure and electrical connections are cut off. -
Page 10: Technical Drawing
SK-50 9.TECHNICAL DRAWING... - Page 11 SK-50...
- Page 12 SK-50...
- Page 13 SK-50...
- Page 14 SK-50...
- Page 15 SK-50 9.DISCHARGE CAPACITIES...
- Page 16 SK-50 USER MANUAL FLOAT TYPE STEAM TRAP SK-50 / SK-50B HEAD OFFICE - FACTORY Atatürk Sanayi Bölgesi Hadımköy Mahallesi Mustafa °nan Caddesi No: 44 Arnavutköy - °STANBUL Tel: +90 212 771 01 45 (pbx) | Fax: +90 212 771 47 27 info@ayvaz.com | www.ayvaz.com...
Need help?
Do you have a question about the SK-50 and is the answer not in the manual?
Questions and answers