Advertisement
2022-11/Version 1.0
THIS BASIN MUST BE INSTALLED IN ACCORDANCE WITH
AS/NZ 3500.2 AND LOCAL REGULATIONS. THIS BASIN MUST
BE INSTALLED BY A LICENSED PLUMBER.
Before you begin
Check the product for damage, if the product is damaged return to the store of purchase.
Check the product is complete with all components required to install. This product is to
only be installed by a licensed plumber, and must be installed in accordance with these
instructions, failing to do so will void warranty.
Installation instructions
1. This basin is supplied with a cut out template, due to manufacturing variations it is
recommended you cross check the cut-out template dimensions against the physical
basin dimensions and adjust cut out size as, or if required.
2. Lay the template in the desired position on the bench and tape down to secure the
template into position.
3. Prior to cutting the hole, check to ensure the cut-out does not interfere with drawers or
internal walls of the vanity cabinet.
4. Cut the hole into the vanity cabinet top.
5. Fit the basin into the cut-out hole to ensure the basin fits correctly and no
adjustment of the cut-out hole is required.
6. Prior to fitting the basin it is recommended the tapware and waste are assembled to the
basin for ease of assembly.
7. Prior to fitting the basin to the bench top run a plumbers grade silicone seal around the
cut-out hole.
8. Insert the basin into the bench top cut-out and align so the basin is square to
cabinet top.
9. Apply a bead of plumbers grade silicone around the outer edge of the basin to prevent
water going under the basin. Allow the silicone to dry.
10.Connect Basin to drainage system as per Australian standards and local authority
requirments.
further
the vanity
DU7130F-N Installation Instructions
Advertisement
