Table of Contents
Advertisement
Configuring the VCR MSE 8220
Step one: Log in to the blade
All administration of the VCR MSE 8220 is performed via the web interface.
To log in to the web interface of the VCR MSE 8220:
1
Log in to the Supervisor's web interface.
2
Go to
Hardware > Blades
3
Click
Click here to log in
name
admin
Cisco recommends that you change the admin account to use a password
i
as soon as possible. To do that, go to
provide the required user information.
Step two: Using an H.323 gatekeeper or SIP registrar (optional)
Using an H.323 gatekeeper makes it easier for H.323 end-users to watch and make
recordings using directory numbers rather than requiring them to know the IP
address or host name of the blade. Likewise, a SIP registrar makes it easier for SIP
users to watch and make recordings.
To configure the blade to use an H.323 gatekeeper:
1
In the web interface of the VCR MSE 8220, go to
2
Enable
H.323 gatekeeper usage
the online help for further assistance.
3
Click
Apply changes
To configure the blade to use a SIP registrar:
1
In the web interface, go to
2
Configure the settings you require, using the online help for further assistance.
3
Click
Apply changes
Before you configure the VCR MSE 8220 to use, and register recordings
i
to, a SIP registrar, you must set up the blade and its recordings on that SIP
registrar.
and click the IP address of the blade.
, and then click
with no password.
.
Settings > SIP
.
Configuring the VCR MSE 8220
Change log in
, click the
Users
Settings > Gatekeeper
and configure the settings you require, using
.
and enter the user
link, and
admin
.
10
Advertisement
Table of Contents
