Compaq 517212-001 Upgrade And Service Manual page 10

4 Place the drive so the guide screws fit into the guide
screw slots. The drive manufacturer's label should be
visible when the drive is in place.
5 Push the hard drive back into the bay and then to the
right until it locks. When the drive is properly located,
the threaded holes in the drive line up with the holes
in the drive bay, and the power and data cables will
route properly.
8
6 Replace the hard drive retention screws and tighten
7 Reconnect the power cable and data cable to the
— Removing and Replacing the Hard Disk Drive
517212-001
them.
optical disc drive.
NOTE: The location of the cable connections may
vary with the optical drive model in your computer.