Table of Contents
Advertisement
7 Technical data
7 Technical data
7.1 Medium
Working medium:
Control medium:
7.2 Temperature
Media temperature:
Sterilization temperature:
Control medium temper-
ature:
Ambient temperature:
Autoclavability:
GEMÜ 652
Corrosive, inert, gaseous and liquid media which have no negative impact on the physical and
chemical properties of the body and diaphragm material.
Inert gases
Connection of the control medium is only required for diaphragm replacement. Under normal work-
ing conditions, control air is not required.
-10 — 100 °C
EPDM (Code 17)
EPDM (Code 19)
PTFE/EPDM (Code 54)
The sterilization temperature is only valid for steam (saturated steam) or superheated water.
If the sterilization temperatures listed above are applied to the EPDM diaphragms for longer periods of time, the
service life of the diaphragms will be reduced. In these cases, maintenance cycles must be adapted accord-
ingly.
This also applies to PTFE diaphragms exposed to high temperature fluctuations. The maintenance cycles must
be adapted accordingly.
0 — 60 °C
0 — 60 °C
Actuator version
2T1, 2T2, 2T3
3T1, 3T2, 3T3, 3T4, 3T5
4T1, 4T2, 4T3, 4T4, 4T5
5T1, 5T2, 5T3, 5T4, 5T5, 5T6
max. 150 °C, max. 180 min per cycle
max. 150 °C, max. 180 min per cycle
max. 150 °C, permanent temperature per cycle
10 / 26
Autoclavability
Autoclavable
with special version
www.gemu-group.com
Advertisement
Table of Contents
