Page 1
Solar Animal Repellent USER MANUAL RB-101 ®...
Page 2
Thanks for purchasing this item. Please read and understand these instructions and keep this manual for future reference. This item uses solar power to recharge the batteries so it is always working after the battery recharged. The Passive Infrared sensor (PIR) detects motion and triggers the ultrasonic speaker emitting a tone that animals can feel and chase away these animals.
Important tips Here are some general tips to help you to use your repellents for repelling animals: Make sure that batteries are working well. It is suggested for getting the desired result, charge the batteries 3 times for 6 hours to reactive them (since your device hasn’t been working for more than 2 months).
Operation A strong ultrasonic wave to frighten animals. The wave is » activated when an animal enters the PIR Sensor range and then the animals feel uncomfortable and will run away from the area. A strong flashing LED to scare animals. The strong flashing »...
Page 5
SET UP “Sensitivity” Knob (Left knob): You can adjust the item sensitivity and distance. By turning the knob clockwise, you increase the range of protection. “Frequency” Knob (Right knob): This is to control frequency. By turning the knob clockwise, the frequency will be increased. “Frequency”...
Page 6
Assemble and Installation Remove the battery compartment on the back; Install 3x AA, 1.2 V rechargeable batteries, and then close the battery compartment. (battery is included, so this is not needed) Place the unit pointed towards the area that you want to protect (for example, in the flowerbed or against the wall etc.) Remember to choose a place where the solar panel on the top can get sunshine as long as possible.
Technical Specification Infrared sensor angle: 110 degrees » Detection range: 8-9 meters depending on animals size (the » bigger size, the larger range) Power supply: solar power + 3 X Ni-mH AA rechargeable » batteries, or 9V, 1A adapter. (An USB cable is included for you to charge) When you charge the item with USB cable, red light will be »...
Battery issues If new batteries are in the product, and you do not want to use the item for a long time (more than 1 month), the batteries power may be fully released. It is suggested to charge the batteries 3-5 times to activate so they will become normal to use.
Page 11
Raymond Broox Inc. www.raymondbroox.com contact@raymondbroox.com...
Page 12
Raymond Broox Inc. www.raymondbroox.com contact@raymondbroox.com CA,USA...