Advertisement
Quick Links
Advertisement
Related Manuals for Broox RB-101
Summary of Contents for Broox RB-101
- Page 1 Solar Animal Repellent USER MANUAL RB-101 ®...
- Page 2 Thanks for choosing Broox animal repellent! Please make a careful study of the manual and keep it for future reference. Solar energy is used for charging the device battery. After initial charging via USB cable the device will get charged via solar energy when it is exposed to sufficient sunlight.
-
Page 3: Important Tips
Important tips Make sure that the batteries work well. It is strongly recommended that the device get charged before the first use. And the most effective way for reactivating the batteries is as follow; charge the device via the USB cable which is inside the package for 6 hours, unplug the device and repeat it for another 6 hours, unplug it and repeat for the third time. -
Page 4: Operation
Mode 4 contains flashing light as well as an alarm sound that get activated simultaneously when a movement is detected by PIR, which is the most effective way for repelling the animals. Mode 5 produces the ultrasonic sound and flashing light at the same time. - Page 5 SET UP There are two knobs on the device: • Sensitivity knob (left knob) • Frequency knob (right knob) “Sensitivity” knob helps you to adjust the impact distance of the ultrasonic waves. By turning the knob clockwise, the range of protection of the device will increase.
- Page 6 Assemble and Installation Charge the device via the USB cable inside the package as follow. Battery is included. Charge the repellent for six hours, unplug the device and plug again and charge it for another 6 hours. Repeat it for the third time. Consider a suitable place for the repellent regarding the points mentioned in Important Tips section.
- Page 7 - Assemble and Installation...
-
Page 8: Technical Specification
Technical Specification Charging Light Indicator: While charging the repellent via the » USB cable the Indicator Light is RED, and it turns BLUE when the device is fully charged. Green LED Light: Turns on whenever the repellent detects a » motion and gets activated Infrared Sensor Angle: 110 degree »... - Page 9 - Technical Specification...
-
Page 10: Battery Considerations
Battery Considerations In case the repellent is not going to be used for a long time (more than 1 month), the batteries will discharge. To reactive the batteries, they must be charged 3-5 times before reprocessing the repellent. When the batteries that have been used for a long time and get fully charged in a short time, it means that they need to be changed with new batteries. - Page 11 Raymond Broox Inc. www.raymondbroox.com contact@raymondbroox.com...
- Page 12 Raymond Broox Inc. www.raymondbroox.com contact@raymondbroox.com CA,USA...