Advertisement
8. Install and adjust the throttle cable (not included). Before connecting the kickdown
inner wire to the throttle arm, make sure that the throttle cable is properly adjusted.
Verify that the throttle is wide open while you have a helper hold the accelerator
pedal to the floor. Once you are sure that the throttle cable is adjusted correctly,
slide the kickdown throttle body fitting onto the kickdown cable inner wire, and
connect the kickdown throttle body fitting to the hex carb fitting.
9. This step will also be much easier with a helper. Slide the kickdown cable end stop
onto the inner wire. Move the throttle to wide open and hold it there while pulling
the kickdown inner wire as tight as possible. Slide the cable end stop up against
the kickdown throttle body fitting and tighten the set screw using the supplied
5/64" Allen wrench. Release the throttle.
When the kickdown cable is properly adjusted you should be able to open the
throttle to the wide open position without interference from the kickdown cable;
and with the throttle wide open, you should not have any slack in the kickdown
cable.
Double check to be sure that all throttle and kickdown linkages operate freely
without binding. Then, test drive. Once the kickdown cable is correctly adjusted
and operating properly you can cut off the excess inner wire, leaving about 1/2"
extending beyond thecable end stop to allow for future adjustment if needed.
Final installation should look like Fig. 4 or 5 and Fig. 8.
Throttle Arm
Hex Carb
Fitting
Kickdown Throttle
Cable End Stop
Body Fitting
Figure 8
Carb End
Tear Drop
Kickdown Kit shown installed with Proflow Throttle Cable
(not included) and Proflow Cable Bracket (not included).
PROFLOW LIMITED WARRANTY
This product is warranted to be free from defects in materials and
workmanship for a period of one year from the original date of purchase.
EMAIL: sales@proflow.com.au
Cable
Carburettor
Adjuster
Base
Cable
Bracket
Kickdown
Mounting Bracket
Kickdown Cable
Housing
PHONE:
1300 879 879
Throttle
Cable
Housing
Ferrule
4
Advertisement
