Pre-Start; Starting And Stopping - Ariens Grand Sierra 931038 Owner's/Operator's Manual

Light Switch
With key in run position, flip light switch
forward to turn headlights on and push
switch rearward to turn them off.
Hour Meter
Hour Meter operates when Ignition Switch is
in the RUN position and records actual time
engine operates.
Power Take-Off (PTO) Indicator Light
PTO Indicator Light glows red when PTO Switch Knob(s)
is/are pulled out (ON) and a clutch engaged, indicating
that implement PTO is engaged.
IMPORTANT: Keep a record of Hour Meter readings for
recommended Lubrication and Maintenance intervals.
NOTE: For accurate readings be sure Ignition Switch is
OFF when tractor is not in operation.
P -S
RE TART
CAUTION
Make sure all hardware is tight, all safety devices in
place and all adjustments made correctly.
Air Cleaner
Check air filter for dirt. Clean as required. See
Maintenance Section.
Engine Fuel and Crankcase Oil
Check and add fuel if required. Check that engine
crankcase oil is full. Refer to General Maintenance
Section.
Safety Interlock System
Engine must shut off if the operator attempts to leave the
seat with the transmission engaged, parking brake
disengaged or PTO engaged.
NOTE: Check interlock system before each use.
WARNING
Safety interlock system failure and
improper operation of unit can result in
death or serious injury. Check system to
make sure it is functioning properly.
STOP
Seat Adjustment
On models with seat slides, seat can be adjusted forward
and rearward by moving the handle on the seat slides
towards the center of the tractor. Hold handle while
sliding seat into a comfortable position, release handle to
ensure that the seat is locked into position.
Be sure all controls can be reached safely from
operator's position.
5/00
S
TARTING AND
DO NOT attempt to start your engine at this time.
Thoroughly read entire Operator's Manual first.
Starting:
1. Disengage PTO Switch(es) and put Speed Selector
in neutral (N).
2. For a cold engine, pull out choke.
3. Place ignition key in ignition switch and turn it
clockwise to (Start) position. When engine starts,
release ignition key.
If engine fails to start on first attempt, turn ignition key
(OFF), wait a few seconds and try again. Best starter life
is obtained by using short starting cycles.
IMPORTANT: DO NOT operate starter motor more than
15 seconds per minute, as overheating and damage can
occur.
4. When engine starts, gradually push choke in.
5. After engine has started, allow it to warm up before
applying load.
IMPORTANT: Run engine at 1/3 of (FAST) engine speed
for at least five minutes in below freezing temperatures to
prevent internal damage to engine and transaxle.
Attachments should be operated at full throttle unless
otherwise specified in attachment Owner's Manual.
Select desired travel speed with Speed Selector.
Stopping
Set Parking Brake to prevent unit from rolling and
remove Ignition Key to prevent accidental starting or
unauthorized use.
To stop tractor, return Speed selector to neutral (N) either
by hand or depress Neutralizer Pedal. Step on Brake
Pedal to stop tractor if it continues to roll.
Emergency Stops
For emergency stops, depress both Neutralizer and
Brake Pedals at the same time.
NOTE: Practice using Neutralizer Pedal for all slowing
down and stopping operations. This will make emergency
stops become automatic.
®
Ariens Grand Sierra
S
TOPPING
WARNING
CAUTION
9
GB -