Advertisement
3.2
BACK ASSEMBLY (Fig.2)
3.2.1 Place the back panels (A & B) on a suitably protected flat surface to prevent scratching.
3.2.2 Interlock the tabs into the slots on the back panels and slide together until the two panels are fully engaged.
3.3
SIDE ASSEMBLY (Fig.3)
3.3.1 Hold the side panels (C & D) at a slight angle and fit the tabs on the back panels into the slots of the side panels and slide
down to engage.
3.4
INNER CROSS MEMBER ASSEMBLY (Fig.4)
3.4.1 Insert the cross member (E) as shown in Fig.4 and secure using screws (O) and washers (P).
3.5
BASE ASSEMBLY (Fig.5)
3.5.1 Slide the base (G) into position and locate onto the tabs on the back and side panels. The front edge fits over the inner cross
member.
3.6
OUTER CROSS MEMBER ASSEMBLY (Fig.6)
3.6.1 Fit the outer cross member (F) and secure with the two plastic oval inserts (L) and two hinge inserts (M).
3.7
TOP ASSEMBLY (Fig.7)
3.7.1 Fit the top (H) to the cabinet and push down until the tabs lock into position, fit two plastic oval inserts (L) and two hinge
inserts (M) as shown in Fig.7. With the aid of another person carefully lift the cabinet from the top into an upright position.
Fig.2
Fig.4
Fig.6
Fig.3
Fig.5
Fig.7
SC01
Issue No: 1 - 28/08/08
Advertisement
