PURAERO PA-600-HAS Owner's Manual

Commercial hepa air scrubber

Advertisement

Quick Links

COMMERCIAL HEPA AIR SCRUBBER
CM
C
US
READ AND SAVE THESE INSTRUCTIONS
OWNERS MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PA-600-HAS and is the answer not in the manual?

Questions and answers

Summary of Contents for PURAERO PA-600-HAS

  • Page 1 COMMERCIAL HEPA AIR SCRUBBER READ AND SAVE THESE INSTRUCTIONS OWNERS MANUAL...
  • Page 2 It's designed to accept 16"inlet flex duct and 10"lay flat outlet duct for a variety of operating set-up options. PA-600-HAS delivers a maximum 675 CFM of HEPA filtered air, while drawing less than two amps of power. This makes PA-600-HAS the perfect for a variety of remediation projects where space and power are at a premium.
  • Page 3 A detachable trapazoid shaped exhaust ring is supplied that will allow 10"round lay-flat plastic duct to be attached to the PA-600-HAS outlet To attach ducting to the collar, remove the ring from the unit by pressing release tab at the top of the grill. Put the plastic duct end through the inside of the ring.
  • Page 4 Negative Air Ducting The PA-600-HAS can be used to filter and exhaust air from a space. When exhausting to outside the space, the space will be under a slight negative pressure. This will help prevent airborne particles from leaving the space, because the negative pressure will draw air in through openings in the space's exterior surfaces.
  • Page 5 Before each use inspect for damage, blocked inlet or outlet. Inspect the GFCI to ensure it is not in a "tripped" condition. Push RESET to reset the GFCI. When the PA-600-HAS is first turned on, check for excessive vibration. If the unit vibrates excessively or if impeller rubs on housing.tum off the unit immediately.
  • Page 6 PURAERO'S WARRANTY POLICY: 1-Year Warranty Subject to the conditions stated below. PURAERO offers a limited warranty on parts and labor on the following equipment, parts and accessories to be free from defects in material and workmanship for a period of one year to the original purchaser.
  • Page 7 PA-330-AM-BL MOVER ASSEMBLY ITEM PART ITEM PART DESCRIPTION DESCRIPTION NUMBER NUMBER NUMBER NUMBER 600-01 SCREW 600-14 POWER CORD 600-02 RUBBER FOOT 600-15 NUT, HEX 600-03 REMOVABLE FOAM CAP 600-16 GFCI OUTLET, FEMALE PLUG 600-04 UPPER HALF SHELL 600-17 CIRCUIT BREAKER 600-05 BUCKLE 600-18...

Table of Contents