Table of Contents
Advertisement
8. ELECTROMAGNETIC COMPATIBILITY
Electromagnetic Compliance
The Track Bridge has been tested for compliance with current regulatory
standards in regards to EMI (electromagnetic interference).
Use of this equipment adjacent to or stacked with other equipment
should be avoided because it could result in improper operation. If
such use is necessary, this equipment and the other equipment should
be observed to verify that they are operating normally.
Use of accessories and cables other than those specified or provided by
the manufacturer of this equipment, could result in increased
electromagnetic emissions or decreased electromagnetic immunity of
this equipment, and result in improper operation.
Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than
30 cm (12 inches) to any part of the Track Bridge, including cables
specified by the manufacturer. Otherwise, degradation of the
performance of this equipment could result.
Electromagnetic Emissions - For All Equipment and Systems
The Track Bridge is intended for use in the electromagnetic environment specified below.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
Part No. 001300-EN, 14-m02-2023 Track Bridge /Track Bridge Bariatric Owner's Manual
Guidance and Manufacturer's Declaration -
Compliance
Group 1
Class B
Not applicable
Not applicable
WARNING
Electromagnetic environment - guidance
The Track Bridge uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any
interference with nearby equipment.
The Track Bridge is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
supplying buildings used for domestic purposes.
29
Advertisement
Table of Contents
