Advertisement
Table of Contents
- 1 Detailed Instructions
- 2 Quick Start
- 3 User Maintenance
- 4 Warnings and Precautions
- 5 Cleaning and Disinfecting
- 6 Electromagnetic Compatibility (Emc)
- 7 Guidance and Manufacturer's Declaration - Electromagnetic Immunity
- 8 Guidance and Manufacturer's Declaration - Electromagnetic Emissions
- Download this manual
Advertisement
Table of Contents
Related Manuals for ThermoTek evolution 2
Summary of Contents for ThermoTek evolution 2
- Page 1 USER MANUAL USER MANUAL Vascular Therapy System (Compressible Limb Sleeve Device) Customer Service Sales: 972-874-4949 Email: CustomerService@thermotekusa.com Web: www.thermotekusa.com 1200 Lakeside Parkway, #200 Flower Mound, TX 75028 Manufactured For: 0V12X1009M01-D01 Rev D 06/17/21...
-
Page 2: Detailed Instructions
Alarm Indicator CONTENTS: The intended use of the EVOLUTION 2 is to aid in the prevention of Deep Vein Thrombosis (DVT) by helping to stimulate blood flow in the legs. This is accomplished by an electronically controlled pump delivering a set amount of air to the leg cuffs that, in turn, compress the calf or calves to aid blood flow out of the lower extremities. -
Page 3: User Maintenance
USER MAINTENANCE INTENDED USE The intended use of the ThermoTek Evolution 2 is to aid in the prevention of Deep Vein The ThermoTek Evolution 2 contains no serviceable parts. Thrombosis (DVT) by helping to stimulate blood flow in the legs. This is accomplished Contact ThermoTek Customer Service at 877-242-3232. -
Page 4: Warnings And Precautions
Battery Low: Power down device and power back on. If LED is RED, this indicates that the battery power is order of a physician. low. Plug in to charge unit. If this alarm continues to present after charging, call ThermoTek Customer WARNING: This device is not protected against water. Equipment is not Service at 877-242-3232. -
Page 5: Electromagnetic Compatibility (Emc)
TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to the fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the ThermoTek Evolution 2 is used exceeds the applicable RF compliance level above, the ThermoTek Evolution 2 should be observed to verify normal operation. -
Page 6: Guidance And Manufacturer's Declaration - Electromagnetic Emissions
Emissions Tests Compliance Electromagnetic Environment Guidance The ThermoTek Evolution 2 uses RF energy only for its internal function. Therefore, its RF emissions are very low and are not RF Emissions CISPR11 Group 1 likely to cause any interference in nearby electronic equipment.
Need help?
Do you have a question about the evolution 2 and is the answer not in the manual?
Questions and answers